How to remove terminal capability set in setup message?
Posted: Wed Feb 27, 2019 4:44 pm
Hi:
I am trying to integrate H.323 Plus into my project, for some particular reason I need to have a simple setup message without TCS, just waiting for remote peer's response with TCS in connect message to decide which media capabilities should be used.
But what I found is that no matter if I enable/disable "faststart" flag, I still can see TCS and MSD in setup message, the only difference is that when using "faststart", "OpenLogicalChannel" can be seen in setup message.
I'm wondering if it is because H323Plus was optimized using "Parallel H.245" by default? If so, how can I disable this "Parallel" feature?
http://toncar.cz/Tutorials/VoIP/VoIP_Pr ... tions.html
Thanks!
I am trying to integrate H.323 Plus into my project, for some particular reason I need to have a simple setup message without TCS, just waiting for remote peer's response with TCS in connect message to decide which media capabilities should be used.
But what I found is that no matter if I enable/disable "faststart" flag, I still can see TCS and MSD in setup message, the only difference is that when using "faststart", "OpenLogicalChannel" can be seen in setup message.
I'm wondering if it is because H323Plus was optimized using "Parallel H.245" by default? If so, how can I disable this "Parallel" feature?
http://toncar.cz/Tutorials/VoIP/VoIP_Pr ... tions.html
Thanks!