According to GNU Autoconf online manual, the
AC_CHECK_FILE (file, [action-if-found], [action-if-not-found]) is used to check whether file
file exists on the
native system. In other words, the use of AC_CHECK_FILE function under a cross compilation will terminate configure process with a
warning: Cannot check for file existence when cross compiling message. This happens if I tried to cross compile H323Plus package for OpenWRT platform because the
configure.ac scripts file uses the AC_CHECK_FILE function to check for the ${PTLIBDIR}/version.h and ${OPENH323DIR}/../ptlib/version.h files. The work around to this is either to replace the AC_CHECK_FILE function with a
test -f or other autoconf supported function. If you see the patch I included below, you will notice I have replaced the AC_CHECK_FILE function with the AC_CHECK_HEADER function.
Code: Select all
+++ b/configure.ac
@@ -66,11 +66,11 @@ dnl look for ptlib, use a preference ord
dnl at same level, home directory, /usr/local or /usr.
if test "${PTLIBDIR:-unset}" != "unset" ; then
- AC_CHECK_FILE(${PTLIBDIR}/version.h, HAS_PTLIB=1)
+ AC_CHECK_HEADER(${PTLIBDIR}/version.h, HAS_PTLIB=1)
fi
if test "${HAS_PTLIB:-unset}" = "unset" ; then
- AC_CHECK_FILE(${OPENH323DIR}/../ptlib/version.h, HAS_PTLIB=1)
+ AC_CHECK_HEADER(${OPENH323DIR}/../ptlib/version.h, HAS_PTLIB=1)
if test "${HAS_PTLIB:-unset}" != "unset" ; then
PTLIBDIR="${OPENH323DIR}/../ptlib"
else
Honestly, I don't know if the above substitution is appropriate or not; however, it gets the job done and configure process is now capable of verifying the existence of both version.h files as shown below. At any rate, if this substitution deemed to be properly done, please feel free to apply the patch to the H323Plus configure.ac file.
Code: Select all
checking for unistd.h... yes
checking /opt/openwrt-svn-trunk/build_dir/target-mipsel_uClibc-0.9.32/ptlib2_svn/version.h usability... yes
checking /opt/openwrt-svn-trunk/build_dir/target-mipsel_uClibc-0.9.32/ptlib2_svn/version.h presence... yes
checking for /opt/openwrt-svn-trunk/build_dir/target-mipsel_uClibc-0.9.32/ptlib2_svn/version.h... yes
PTLib prefix set to.... /opt/openwrt-svn-trunk/build_dir/target-mipsel_uClibc-0.9.32/ptlib2_svn
checking Checking PTLib version 2.11.0... ok
configure: Disabling H.235.6